Print notice

| Petroleum and gas safety alert | No.15 V 1 | 08 December 2003

Using cheater bars on hand tools

What happened?

Recently, an incident occurred on a drilling site where a stillson wrench broke off at the handle after a six foot long cheater bar was attached to dislodge a drill bit from a drill string. The incident resulted in a driller receiving injuries to his face as a result of a piece of metal from the handle of the stillson flying up and hitting him.

Key Issues

Recommendations

The practice of using cheater bars on hand tools should be stopped immediately. There is always an alternate way of doing the job safely. Managers and supervisors should lead the way in outlawing this practice.

Authorised by John Fleming -

Contact: Chief Inspector, Petroleum and Gas

Issued by Queensland Department of Mines and Energy

All information on this page (Using cheater bars on hand tools - https://www.rshq.qld.gov.au/safety-and-health-alerts/petroleum-and-gas/using-cheater-bars-on-handtools) is correct as of time of printing (Nov 16, 2026 1:22 pm).