Print notice

| Petroleum and gas safety information bulletin | No.7 V 1 | 08 January 2020

Incorrect use of semi-rigid connectors

What happened?

Note: Semi-rigid connectors have been known by the term limited flexibility connectors in the past. Australian standards are being updated to refer to these components as semi-rigid connectors. In the meantime the two terms should be considered interchangeable.

The Inspectorate has identified an increasing issue with the incorrect use and application of semi-rigid connectors (limited flexibility connectors) and gas hose assemblies.

The issues include:

  1. The use of a semi-rigid connectors in situations where a gas hose assembly should be used, for example to connect commercial catering equipment; and
  2. The use of semi-rigid connectors as part of consumer piping in caravans, recreational vehicles and camper trailers.

A semi-rigid connector is an assembly of semi-rigid pipe, with permanently attached end fittings, that is designed for infrequent movement and that is certified to ‘AS4631 Semi-rigid connectors for gas’.

A Gas Hose Assembly is a flexible tube or pipe complete with end couplings and that is certified to ‘AS/NZS1869 Hose and hose assemblies for liquefied petroleum gases (LP Gas), natural gas and town gas’. (Note: Different classes of hose assembly are required dependent on pressure and temperature.

Semi-rigid connectors and gas hose assemblies should only be installed where permitted by:

Key Issues

Recommendations

Gas fitters should familiarise themselves with the difference between a semi-rigid connector (marked ‘AS4631’) and a gas hose assembly (marked ‘AS/NZS1869’).

Gas fitters should ensure that:

Gas product suppliers should ensure they supply the appropriate materials, fittings and components, for example: if a gas hose assembly is requested by a gas fitter, a semi-rigid connector is not appropriate.

References and further information

Definitions for semi-rigid connectors/limited flexibility connectors and gas hose assemblies can be found in section 1 of AS/NZS5601.1.

Information on acceptable materials, fittings and components can be found in AS/NZS5601.1 section 4 and AS/NZS5601.2 section 5.

The correct use and application of semi-rigid connectors/limited flexibility connectors and hose assemblies can be found in AS/NZS5601.1 sections 3 to 6 and AS/NZS5601.2 sections 3 to 9.

Queensland legislation:

The Petroleum and Gas (production and Safety) Act 2004

The Petroleum and Gas (Safety) Regulation 2018

Current Queensland legislation at: https://www.legislation.qld.gov.au/browse/inforce

Australian standards:

Gas component and appliance approvals:

The Gas Technical Regulators Committee (GTRC) at: http://www.gtrc.gov.au/

The GTRC National Certification Database at: http://equipment.gtrc.gov.au/

Contact the inspectorate:

Website: https://www.business.qld.gov.au/industries/mining-energy-water/resources/safety-health/petroleum-gas

Email: paul.beaumont@dnrme.qld.gov.au

Phone: 07 54596189

Authorised by Paul Beaumont -

Contact: Paul Beaumont, Principal Inspector , +61 7 5459 6189

Issued by Queensland Department of Natural Resources, Mines and Energy

All information on this page (Incorrect use of semi-rigid connectors - https://www.rshq.qld.gov.au/safety-and-health-alerts/petroleum-and-gas/incorrect-use-of-semi-rigid-connectors) is correct as of time of printing (Nov 17, 2026 10:50 am).