| Mines safety bulletin | No.136 V 1 | 27 August 2013
Electricity is a potential hazard found in all areas of mining operations, from extraction and processing to accommodation, storage and administration facilities, and it can range from a few volts up to 220kV.
Electric shocks as low as 50V AC may cause serious ill effects. More significant electrical faults may cause arc flashes, cubicle explosions and fires, and depending on where this occurs, have potentially catastrophic implications.
So it is important the design, construction, commissioning, operation and decommissioning of electrical equipment and installations is carried out to relevant legislation, standards, codes and good engineering practice. A maintenance strategy, including consideration of failure modes of protection equipment and the use of back up protection should be developed before completion and implemented immediately after the equipment is commissioned.
Queensland mining safety and health legislation requires electrical installations on mine sites to be designed, constructed, tested and maintained so that risks are at acceptable levels. On non-coal mines and quarries, the Mining and Quarrying Safety and Health Regulation 2001, (the Regulation) applies. In the Regulation:
For coal mines, the Coal Mining Safety and Health Regulation 2001 has mostly similar provisions.
Reported high potential accidents and incidents also reflect the importance of these requirements, and safety alerts and bulletins published as a result of incidents include:
Certain electrical design and testing data are required to determine that the electrical installations and equipment will be safe for use, fit for purpose and to determine that risks are at acceptable levels throughout the life cycle of the mine. Taking into account that this varies somewhat with the size and complexity of the mining operation and plant, it is recommended that any new or significantly upgraded electrical installation, or installation that carries in excess of 800 Amps, has:
included among the data used to determine that risks are at acceptable levels.
As well as the types of installation mentioned above, mining safety and health regulators can require any other site, appearing to have an unacceptable level of risk in any of these areas, to show how these risks have been addressed.
Contact: minesafetyandhealth@dnrm.qld.gov.au
Issued by Queensland Department of Natural Resources and Mines
Find more Safety and Health Alerts
Search the hazards database
All information on this page (Mine and quarry electrical installation design expectations - https://www.rshq.qld.gov.au/safety-and-health-alerts/mines/mine-and-quarry-electrical-installation-design-expectations) is correct as of time of printing (Nov 23, 2026 2:15 am).