| Explosives information bulletin | No.11 V 2 | 20 September 2007
Flyrock can best be defined as, the undesirable throw of debris from a blast. It is generally found to originate around the collar of the blast hole or the face of a blast and to have been caused by incorrect selection or application of burden, stemming length or by blast holes being initiated out of sequence.
Because the potential for severe injury or property damage exists, precautions against flyrock must be foremost in the mind of the blast designer and shotfirer. The closer to persons or property that blasting is carried out, the greater the awareness, care and degree of protection exercised in avoiding incidents of flyrock.
One important consideration often overlooked, is the structure of the rock. Fissures, joints and weakness planes are not necessarily the same from location to location even within the same blast area. Because weathering of the surface rock is generally more pronounced than in the deeper lying strata, it is important that the surface rock is inspected for faults and planes which are likely to assist in the creation of flyrock. Previous excavations can give significant information about the rock structure, as can information from the driller of the blast holes.
Area surrounding the blast site must be inspected to determine distances to protected works eg : residences, roads, public places, dangerous goods storage and due consideration of same must be taken in determining the degree of protection necessary.
Good blast design is generally the primary method of avoiding flyrock.
Note: Trench blasting and blasting where bench heights are small compared to the burden are commonly regarded as providing greatest potential for flyrock because the degree of confinement and the specific charge are high and the charge is sometimes placed close to the surface.
While the blast pattern generally determined by experience may be satisfactory, inaccuracies in drilling or incorrect blast hole angle can cause quite large deviations from the planned pattern with excessive noise, vibrations and/or flyrock resulting. The extra time spent on making sure that the blasthole is in the right position is especially warranted. Instruments should be used to set out the drilling pattern. There will be difficulty in estimating the burden in hilly terrain.
The correct charge weight must be employed in the blast hole. When using ANFO or any other free running explosive, pour measured quantities of the explosives into the hole and monitor the build up of the explosive column by tape measure or wooden pole. This is to avoid overcharging which may result from fissures or chambers in the rock.
Where any doubt exists, or where the blast situation demands added precautions eg : shallow blasting or proximity to protected works, sufficient cover must be placed on the blast to further minimise the possibility of resulting flyrock.
Where backfilling is used to cover loaded holes this should be sorted material without stones. The cover should be placed with care to avoid damage to connecting wires, shock tube or detonating cord trunklines and should be to a minimum depth, which would eliminate flyrock.
If using blasting mats to provide cover, the following precautions should be observed:
Experience has shown that nearly all incidents of flyrock could have been avoided if the proper precautions had been taken. It is the responsibility of the blast designer and the Shotfirer to ensure that due consideration is given to the prevention of flyrock from the early stages of blast planning and that all necessary steps are taken to minimise its occurrence. It may also be necessary to close off roads, walkways etc, during a blast to ensure flyrock is not a risk to the community.
Failure to adhere to normal safety practices in this regard is a breach of the duty of care principle and may jeopardise licences granted by the Chief Inspector of Explosives in Queensland.
A. Australian Standard AS2187 Part 2, Use of Explosives.
Contact: explosives@dnrm.qld.gov.au
Issued by Queensland Department of Mines and Energy
Find more Safety and Health Alerts
Search the hazards database
All information on this page (Precautions against flyrock - https://www.rshq.qld.gov.au/safety-and-health-alerts/explosives/precautions-against-flyrock) is correct as of time of printing (Nov 20, 2026 1:53 am).